Difference between revisions of "Third-party software integration: Apache"

From OpenKM Documentation
Jump to: navigation, search
(Red Hat / CentOS)
(Red Hat / CentOS)
Line 122: Line 122:
 
     RedirectMatch ^/$ /OpenKM
 
     RedirectMatch ^/$ /OpenKM
 
     <Location /OpenKM>
 
     <Location /OpenKM>
         ProxyPass ajp://127.0.0.1:8009/OpenKM
+
         ProxyPass ajp://127.0.0.1:8009/OpenKM keepalive=On
 
         ProxyPassReverse http://openkm.your-domain.com/OpenKM
 
         ProxyPassReverse http://openkm.your-domain.com/OpenKM
 
     </Location>
 
     </Location>

Revision as of 08:29, 12 August 2014

Expose OpenKM directly from Tomcat or JBoss can be dangerous if you need the application to be accessed from Internet (for example https://issues.jboss.org/browse/JBAS-3861). As result you can be infected by PerlBot. Also this 8080 may be closed by a firewall. For these reasons, is a good idea expose your OpenKM installation through the standard web port 80. In the following steps we explain how to configure Apache to handle these request and forward to Tomcat application server using the AJP13 protocol.

From the Apache documentation: The AJP13 protocol is packet-oriented. A binary format was presumably chosen over the more readable plain text for reasons of performance. The web server communicates with the servlet container over TCP connections. To cut down on the expensive process of socket creation, the web server will attempt to maintain persistent TCP connections to the servlet container, and to reuse a connection for multiple request/response cycles.


Nota idea.png You can see how to configure Apache with SSL at Apache SSL and more article.

Internal IP vs external IP

Your OpenKM can be accessed from two different zones: Internet and LAN. This means that to access this server you need to use two IPs: external IP (Internet) and internal IP (LAN).

The internal IP address (also known as "local IP address") is the address that is assigned by your local network router that often begins with 192.168.x.x. These IP addresses can only be seen by other computers in your local network (LAN) and not by any computers connected in an external network such the Internet.

To reach the Internet or a computer in another network your computer is often assigned an external IP address, which can then be used to refer to the computer in your local network.

Internal ip.png

In the above picture, there are three computers in the local network that have each been assigned their own internal IP address by the router. The ISP is connected to the router and gives the router an external IP address that allows it to communicate with the Internet. On the Internet everyone sees your external IP address, but any information coming from the router is "converted" from the external IP address to the internal IP address.

So if you want your OpenKM installation accessible from both LAN and Internet, the trick here is configure the client computers to resolve your internal IP (192.168.0.50) if they are inside the LAN or the external IP if they are on Internet. To resolve the Internet IP (67.166.214.148) your computer uses the public DNS. So, you need to configure a sort of DNS server inside the LAN or modify every client host file to resolve to the internal IP.

Debian / Ubuntu

The first thing in to install the required Apache software. From Debian / Ubuntu you can install Apache with a single command:

$ sudo aptitude install apache2

Edit the file called /etc/apache2/apache2.conf and configure a ServerName to prevent warnings in the Apache startup process:

ServerRoot "/etc/apache2"
ServerName "your-domain.com"

Enable the proxy module, needed to forward petitions to JBoss:

$ sudo a2enmod proxy_ajp

Now create the configuration file /etc/apache2/sites-available/openkm.conf with this content:

<VirtualHost *>
    ServerName openkm.your-domain.com
    RedirectMatch ^/$ /OpenKM
    <Location /OpenKM>
        #ProxyRequests Off
        #ProxyPreserveHost On
        ProxyPass ajp://127.0.0.1:8009/OpenKM keepalive=On
        ProxyPassReverse http://openkm.your-domain.com/OpenKM
    </Location>
    ErrorLog /var/log/apache2/openkm-error.log
    CustomLog /var/log/apache2/openkm-access.log combined
</VirtualHost>

Nota clasica.png See all ProxyPass parameter at Apache Module mod_proxy documentation.

The VirtualHost ServerName must be other than ServerName in the main Apache configuration. Enable this site configuration:

$ sudo a2ensite openkm.conf

Nota advertencia.png If after restart Apache you see a warning like:
[warn] NameVirtualHost *:80 has no VirtualHosts
you have to change the virtual host definition from <VirtualHost *> to <VirtualHost *:80>


Nota clasica.png If you see an error like:
Invalid command 'RewriteEngine', perhaps misspelled or defined by a module not included in the server configuration

you need to enable this Apache module:

$ sudo a2enmod rewrite
$ sudo a2enmod proxy_http
$ sudo a2enmod headers

You have to enable explicitly the proxy access editing the Apache configuration file /etc/apache2/mods-available/proxy.conf:

<IfModule mod_proxy.c>
  #turning ProxyRequests on and allowing proxying from all may allow
  #spammers to use your proxy to send email.

  ProxyRequests Off

  <Proxy *>
    AddDefaultCharset off
    Order deny,allow
    Allow from all
    Deny from all
    #Allow from .example.com
  </Proxy>

  # Enable/disable the handling of HTTP/1.1 "Via:" headers.
  # ("Full" adds the server version; "Block" removes all outgoing Via: headers)
  # Set to one of: Off | On | Full | Block

  ProxyVia On
</IfModule>

Finally restart Apache:

$ sudo /etc/init.d/apache2 restart

Now you can access your OpenKM installation from http://openkm.your-domain.com/. Another advantage of using Apache is that you can log OpenKM access and generate web statistics.

The syntax is as follows to run syntax tests for configuration files only:

 /usr/sbin/apache2 -t

Red Hat / CentOS

Here you can use the yum application manager to install Apache:

$ sudo yum install httpd

Remember to enable it at boot:

 $ chkconfig httpd --level 2345 on

Now create the file /etc/httpd/conf.d/openkm.conf with this content:

<VirtualHost *:80>
    ServerName openkm.your-domain.com
    RedirectMatch ^/$ /OpenKM
    <Location /OpenKM>
        ProxyPass ajp://127.0.0.1:8009/OpenKM keepalive=On
        ProxyPassReverse http://openkm.your-domain.com/OpenKM
    </Location>
    ErrorLog /var/log/httpd/openkm-error.log
    CustomLog /var/log/httpd/openkm-access.log combined
</VirtualHost>

After that, restart Apache to make effective this configuration.

$ sudo /etc/init.d/httpd restart

Mac OS X

Edit the file called /etc/apache2/apache2.conf and configure a ServerName, enable proxy modules and mod_proxy:

ServerRoot "/usr"
ServerName "your-domain.com"

LoadModule proxy_module libexec/apache2/mod_proxy.so
LoadModule proxy_ajp_module libexec/apache2/mod_proxy_ajp.so

<IfModule mod_proxy.c>
  ProxyRequests Off
  <Proxy "*">
    AddDefaultCharset off
    Allow from all
    Deny from all
    Order Deny,Allow
  </Proxy>
  ProxyVia On
</IfModule>

Now create the configuration file /etc/apache2/sites/openkm.conf with this content:

<VirtualHost *:80>
  ServerName openkm.your-domain.com
  RedirectMatch ^/$ /OpenKM
  <Location /OpenKM>
     ProxyPass ajp://127.0.0.1:8009/OpenKM
     ProxyPassReverse http://openkm.your-domain.com/OpenKM
  </Location>
  ErrorLog /var/log/apache2/openkm-error.log
  CustomLog /var/log/apache2/openkm-access.log combined
</VirtualHost>

Finally restart Apache.

Windows

Install de apache webserver from http://httpd.apache.org/download.cgi ( windows binary no mod_ssl )

Edit the C:\Archivos de programa\Apache Software Foundation\Apache2.2\conf\httpd.conf

# Enable proxy modules
LoadModule proxy_module modules/mod_proxy.so
LoadModule proxy_ajp_module modules/mod_proxy_ajp.so

#Add in bottom 
NameVirtualHost *:80
<VirtualHost *:80>
  ServerName openkm.your-domain.com
  RedirectMatch ^/$ /OpenKM
  
  ProxyRequests Off
  ProxyVia On
  
  <Proxy *>
    AddDefaultCharset off
    Order deny,allow
    Allow from all
    Deny from All
  </Proxy>
  
  <Location /OpenKM>
    ProxyPass ajp://127.0.0.1:8009/OpenKM
    ProxyPassReverse http://openkm.your-domain.com/OpenKM
  </Location>
  
  ErrorLog logs/openkm-error_log
  CustomLog logs/openkm-access_log common
</VirtualHost>

Nota advertencia.png If you have installed IIS started you should change apache port (Listen from 80 to other in httpd.conf)

More info

For more info, visit: